Autodesk Inventor Part Modeling Tutorial #4: Extrude vs. Revolve

In this video tutorial I will take you through each step to create a 3D model of the part shown in Autodesk Inventor using two methods. First I show you how to create it with multiple extrusions. Then I show you how to create it using the Revolve command. If you would like to try

Autodesk Inventor Part Modeling Tutorial #3

In this video tutorial I will take you through each step to create a 3D model of the part shown in Autodesk Inventor. The following tools are used in this tutorial: Extrude, Hole, Project Geometry, Tangent constraints, Colinear constraints, Chamfer, and Mirror. Each sketch is fully dimensioned and constrained before creating the features. The detail

Autodesk Inventor Part Modeling Tutorial #2

In this video tutorial I will take you through each step to create a 3D model of the part shown in Autodesk Inventor. The following tools are used in this tutorial: Extrude, Fillet, Hole, and Chamfer. Each sketch is fully dimensioned and constrained before creating the features. The detail drawing for this part can be

Autodesk Inventor Part Modeling Tutorial #1

In this video tutorial, I walk you through the creation of the part shown below using Autodesk Inventor. The features used in this tutorial include extrusions and fillets. The video uses one of many workflows that would result in the same part.